3. Always replace the fastening clips before reinstalling the panels. See figures 2 and 3 for the proper use of the clips.
Figure 2 - Large ribbed area. For non-leather door panels, use gray clips (999 507 505 40). For leather door panels, use white clips (999 507
582 40)
Figure 3 - Small ribbed area. Use white clips for both leather and nonleather door panels. This type of door panel was introduced into
production as of 11/99.
Power window (left or right)
Only if necessary! Remove according to directions in the workshop manual.
! CAUTION
There is a danger of injury caused by airbag or side, even after the power supply is interrupted. The airbag can be unintentionally triggered if
sufficient time not allowed after disconnection the battery.
> Wait at least one minute after disconnecting the battery proceeding with work.
Complaint 1:
Rattling and knocking noises from the entire door area (left or right side).
Cause:
The door film is striking the door trim panel from the inside.
Repair:
Construct 2 sets of tape strips. Cut 6 strips of sponge rubber tape 70 mm long. Stick together 3 strips so that a total thickness of approximately 10
mm is achieved. Stick both sponge rubber sets on to the door film. See arrows in figure 4.
