Brakes - Brake Rotor Minimum Thickness
SI B 34 05 08
Brakes
August 2008
Technical Service
MODEL
E82, E88 (1 Series)
E46 (3 Series)
E90, E91, E92, E93 (3 Series)
E39 (5 Series)
E60, E61 (5 Series)
E63, E64 (6 Series)
E65, 66 (7 Series)
E85, E86 (Z4)
E52 (Z8)
E83 (X3)
E53 (X5)
E70 (X5)
614
E71 (X6)
INFORMATION
BMW brake discs/rotors are stamped with a Minimum Thickness. The stamped minimum thickness is used to determine whether the brake
discs/rotors require replacement during a brake service, such as pad replacement. However, some motor vehicle inspection procedures require the
measurement of brake discs/rotors. An additional minimum thickness specification for the purpose of motor vehicle inspection is provided in the
Technical Data section of the Repair Manual. Examples of the two specifications are described in this bulletin.
The Stamped Minimum Thickness (MIN TH) is utilized as described below:
New brake pads may only be installed if the brake disc thickness is greater than or equal to the minimum brake disc thickness (MIN TH) [not
including M vehicles].
In the case of M vehicles and perforated (cross-drilled) brake discs, new brake pads may only be installed if the brake disc thickness is greater than
the minimum brake disc thickness (MIN TH).
The Minimum Thickness for general inspection (Motor Vehicle Inspection) is defined as follows:
Nominal size thickness minus 2.4 mm (not applicable to perforated brake discs and M vehicles)
M vehicles and perforated (cross-drilled) brake discs: Nominal size thickness minus 1.6 mm
Note:
The nominal size thickness refers to the width of a new rotor.
Always refer to the Repair Manual for model-specific information.
