BMW Diagnostic & Repair, BMW Wiring Diagrams, BMW Fault Codes (DTC), BMW Technical Service Bulletins, BMW Service Information
Wednesday, 19 July 2017
Campaign - Replace Coolant Expansion Tank SI B17 01 13 Cooling Systems
2013 BMW 328i xDrive Sedan AWD (F30) L4-2.0L Turbo (N20) Copyright ? 2013, ALLDATA 10.52SS Page 1
Vehicle: All Technical Service Bulletins
Campaign - Replace Coolant Expansion Tank
SI B17 01 13
Cooling Systems
March 2013
Technical Service
PERFORM THE PROCEDURE OUTLINED IN THIS SERVICE INFORMATION ON
ALL AFFECTED VEHICLES BEFORE CUSTOMER DELIVERY OR THE NEXT TIME
THEY ARE IN THE SHOP FOR MAINTENANCE OR REPAIRS.
SUBJECT
Service Action: Replace Coolant Expansion Tank
MODEL
F30
SITUATION
The low coolant level warning may come on in the information display.
CAUSE
Insufficient contact at the electrical connector for the coolant level sensor causes an inaccurate reading of the coolant level.
AFFECTED VEHICLES
This Service Action involves certain F30 vehicles with the N20 engine which were produced from 10/2011 to 7/2012.
In order to determine whether a specific vehicle has had this Service Action completed or is affected by this Service Action, first check the B-pillar
label for code number 643. If code number 643 has been punched out, the campaign has already been performed. If code number 643 has not been
punched out, it will be necessary to utilize the "Service Menu" of DCSnet (Dealer Communication System) or the Key Reader. Based on the
response of the system, either proceed with the corrective action or take no further action.
PROCEDURE
Replace the coolant expansion tank and electrical connector for the coolant level sensor.
Note:
This repair procedure involves draining a small quantity of coolant; refill the drained quantity with new BMW Long-term Antifreeze/Coolant
(50/50 mixture). Do not reuse the drained coolant.
PARTS INFORMATION
LABEL INSTRUCTIONS
2013 BMW 328i xDrive Sedan AWD (F30) L4-2.0L Turbo (N20) Copyright ? 2013, ALLDATA 10.52SS Page 2
If the vehicle already has a label from a previous Service Action/Recall Campaign, affix the new label next to the old one. Do not affix one label on
top of another one because a number from an underlying label could appear in the punched-out hole of the new label.
WARRANTY INFORMATION
The repair described in this bulletin is covered under warranty regardless of time or mileage.
Reimbursement for this Service Action will be via normal claim entry utilizing the following information:
Labor operation 00 61 597 is a Plus labor operation.
Sublet calculation: BMW antifreeze/coolant (bulk container reference P/N 82 14 1 467 704 only) - refill/used quantity (50/50 mixture) at dealer net
plus handling. Enter this material cost in sublet and itemize the amount in the claim comment section.