3. Align and attach the supplied templates on the inner side of the door panels (Figure 5).
Note:
Observe the inscriptions on the templates.
3.2 Transfer the templates cut lines onto the door panels.
3.3 Trim the door panel along the mark with jig saw. Then deburr the cut edge with a file.
3.4 Put door trim panel (without loudspeaker) onto the inside of the door and check trim. There must be sufficient space for both bass
loudspeakers, 160 mm.
3.5 Make a hole for the fastening clip in the small insulating mat, as shown in Figure 6, Item A.
DANGER!
Danger (death/serious injury to driver or passenger) in the case of incorrect deployment of the side airbag.
>For vehicles with side airbags, the cut-out for the side airbag (Figure 6, Item B) must be removed before sticking on the large insulation mat.
3.6 Only vehicles with side airbag: Stick supplied insulation mats onto the inner side of each door panel (Figure 6). They are marked left
and right.
3.7 Check correct seating of both sheetmetal nuts on the door (Figure 7, Item A) for fastening of the door trim panel. Clip a sheetmetal nut
into the slot available in the door (Item B).
4. Install door panels.
4.1 Position the door trim panel on the door, aligning the lower edges.
