1. Remove the side nozzle on the passenger's side (Figure 2, Item 1); to do so, pull the covers down and off. On the left in the recess and on the
outer side, undo the two T20 Torx screws, respectively.
2. Pull out the side nozzle.
3. Remove the A-pillar trim on the front passenger's side.
4. Lift the cover of the alarm readiness display (Figure 2, Item 2) and unclip it at the rear.
5. Lift and unclip the defroster cover on the passenger's side (Figure 2, Item 3).
6. To remove the loudspeaker on the passenger's side (Figure 2, Item 4), undo the two T20 Torx screws, raise the outer side of the loudspeaker,
and pull out the loudspeaker. Press the locking lug at the plug and unplug connector.
7. Remove passenger footwell bulkhead (position: Figure 2, Item 5) by undoing two plastic slotted screws and taking off bulkhead.
8. Pull off air guide in footwell on passenger's side (position: Figure 2, Item 6)
9.0 Remove airbag on passenger's side (position: Figure 2, Item 7) as follows:
9.1 Remove ignition key.
9.2 Disconnect battery and cover battery terminals.
WARNING!
Danger of injury caused by airbag: the capacitor in the airbag control module still carries a charge after disconnection of the battery. With a
charged capacitor, assembly work can result in unintentional triggering of the airbag!
> Begin further work on the vehicle only after a waiting time of 1 minute (= capacitor discharging time).
> Observe safety regulations for handling vehicles with airbags - Technical Manual, Group 6, Page 69-1.
9.3 Unscrew the airbag unit from below (2 hexagon-head bolts - a/f 15 mm).
9.4 Pull out unit.
9.5 Pull off electrical lead.
