Wednesday, 13 February 2019

B210110_Dual_Mass_Flywheel_Inspection BMW 335d Sedan (E90) L6-3.0L DSL Turbo (M57Y) Technical Service Bulletin # 610405 Date: 121101


Electrical - Power Mirrors/Windows Inoperative



SI B61 04 05



General Electrical Systems



November 2012



Technical Service



This Service Information bulletin supersedes SI B61 04 05 dated July 2005.



[NEW] designates changes to this revision



SUBJECT



Power Mirrors and/or Windows are Inoperative



MODEL



[NEW] E90



[NEW] Equipped with option 522 (Xenon lights)



SITUATION



The power windows and/or power mirrors are inoperative. The LED on the headlight switch is flashing. There is a check control message for



Windows / Mirrors / Headlights. There may also be a complaint of water in one or both headlights. One of the following fault codes may be stored:



^ 9CBD - Communication with stepper motor box left defective



^ 9CBE - Communication with stepper motor box right defective



^ 9CC1 - Communication with mirror driver side defective



^ [NEW] 9CC2 - Communication with mirror passenger side defective / Right Stepper Motor Controller (SMC) signaling fault



^ 9CCF - Communication with LIN control defective



Left and/or right headlight housing cover is not properly fitted allowing water ingress into the Stepper Motor Controller (SMC) connector.



CAUSE



Left and/or right headlight housing cover is not properly fitted allowing water ingress into the Stepper Motor Controller (SMC) connector.



PROCEDURE



1. [NEW] Perform a vehicle test using ISTA to verify that the faults listed above are stored in the Footwell Module (FRM).



Note:



When the ISTA system message displays: Battery voltage only "XX.XX" V. Please connect charger. Please note the displayed battery



voltage reading in the repair order comments section.



2. [NEW] Inspect the connector at each headlight (X13420 - Left and X13421 - Right) assembly for corrosion and replace as necessary.



2010 BMW 335d Sedan (E90) L6-3.0L DSL Turbo (M57Y) Page 402



3. [NEW] Make sure the headlight access covers (1) are installed correctly.



4. [NEW] Clear the faults and test the headlights for proper function.



[NEW] PARTS INFORMATION



[NEW] WARRANTY INFORMATION