Interior - Front Seat Base Makes Noise On Rough Roads
SI B52 04 12
Technical Service
July 2012
Body Equipment
SUBJECT
Front Seat Base Makes Noise
MODEL
F01
F02
F04
F07
F10
SITUATION
A noise may be heard from the left or right front seat base when driving on rough roads.
CAUSE
The riveting of the seat control bracket to the metal seat base is too loose.
PROCEDURE
Confirm the location of the noise by test driving on a rough road, and then proceed to the next step.
1. Using the Repair Instructions 52 14 040, move the affected seat to
the forwardmost and uppermost position, and then remove the outer seat cover trim.
2010 BMW 750i (F01) V8-4.4L Turbo (N63) Page 44
2. Remove the two screws securing the seat adjustment switch panel and place the panel to the rear side.
3. Release the seat cover from the 3 securing tabs to expose the rivets securing the black plastic bracket.
4. Drill out the 3 rivets and pull back the top of the black plastic panel.
2010 BMW 750i (F01) V8-4.4L Turbo (N63) Page 45
5. Apply the felt tape (50 mm) to the front metal area as shown.
Note:
The seat cover and plastic bracket were removed for illustration purposes only, and show the location of the felt to be applied. After the felt
tape is applied, rivet the bracket to the seat frame. Install all removed parts in the reverse order of their removal, and then quality check the
repair.
PARTS INFORMATION
WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle/SAV Limited Warranty.
2010 BMW 750i (F01) V8-4.4L Turbo (N63) Page 46
