2011 BMW X5 xDrive 35d (E70) L63.0L DSL Turbo (M57Y)
Vehicle: All Technical Service Bulletins
Antitheft System Vehicle Does Not Start
SI B61 05 13
General Electrical Systems
March 2013
Technical Service
SUBJECT
Vehicle Does Not Start
MODEL
E70
E71
Produced up to February 29, 2012
SITUATION
The vehicle does not start. One or both of the following fault codes is stored in the DME:
^ "0x2E3C EWS antitampering protection"
^ "0x32E5 EWSDME interface: Timeout"
CAUSE
Software error in the CAS (Car Access System)
PROCEDURE
1. Perform a vehicle test using ISTA and work through the corresponding test modules linked to the fault codes above. If the
test modules do not identify a root cause, proceed to the next step.
Note:
When the ISTA system message displays: Battery voltage only "XX.XX" V. Please connect charger. Please note the
displayed battery voltage reading in the repair order comments section.
2. Program the vehicle using ISTA/P 2.46.0 or later.
The new integration level: E70123500 or higher
Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest
software.
For information on programming and coding with ISTA/P, refer to CenterNet / Aftersales Portal / Service / Workshop
Technology / Vehicle Programming.
WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle/SAV Limited Warranty.
Labor operation code 00 00 006 is a Main labor operation. If you are using a Main labor code for another repair, use the Plus
code labor operation 00 00 556 instead.
Refer to KSD2 for the corresponding flat rate unit (FRU) allowance. Enter the Chassis Number, which consists of the last 7 digits
of the Vehicle Identification Number (VIN). Click on the "Search" button, and then enter the applicable flat rate labor operation in
the FR code field.
If a control module fails to program correctly or initializations are required, the additional work must be claimed with separate2011 BMW X5 xDrive 35d (E70) L63.0L DSL Turbo (M57Y) Copyright ? 2013, ALLDATA 10.52SS Page 2
labor operations under the defect code listed above; refer to KSD2
Other Repairs
If performing other ISTA diagnostics and the related test plans results with eligible and covered work, claim this work with the
applicable defect code and labor operations listed in KSD2.
Note:
Please follow any TeileClearing (TC) or Diagcode (DC) requirements that may apply to this additional work.
